Bicone Beaded Bracelet

Instructions

STEP 1:

Cut two lengths of stringing wire - 12” inches long.

STEP 2:

Crimp both stringing wires to the loop of the ring of the toggle closure.

STEP 3:

Thread one 3mm silver bead onto both stringing wires.

STEP 4:

On one stringing wire thread a 6mm bicone, a 3mm silver bead then a 6mm bicone bead. Repeat on the other stringing wire, using the same color bicone beads.

STEP 5:

Thread one 3mm metal bead onto both stringing wires. Pull the wire tightly to form a square shape with the beads and to not leave any gap.

STEP 6:

Repeat steps 4 and 5 eleven more times as you rotate evenly through the 3 bicone colors.

STEP 7:

Crimp both stringing wires to the loop of the bar of the toggle closure.

STEP 8:

Use the flush cutters to carefully trim off any excess wire.